1-919-535-3180
[email protected]

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-919-535-3180

Mon-Fri 8AM-5PM EST

[email protected]

MS-FEC2621-0

★ ★ ★ ★ ★ Rated 0/5 Based on ratings.

Rate your purchase of the MS-FEC2621-0

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

Refurbished

$650

Save $90

1 In Stock

✓  2 Year PDF Supply Warranty

Johnson Controls manufactured the MS-FEC2621-0 as a 17-point Metasys MS-series field equipment controller. Within the equipment controller, there are five groups of points, with the following points and the number of points in each group including six universal inputs (UI), two binary inputs (BI), two analog outputs (AO), three binary outputs (BO), and four configurable outputs (CO). To begin, the voltages for each point are 0 to 10 volts DC for the UI and 24 volts AC for the BO. The CO can operate as the UI or the BO, and the AO has the same voltage as the UI. This current is an available measure as the UI has a current range of 4-20 milliamps (mA), and the AO has the same current. It should also be noted that the UI has a resistance range of 0 to 600,000 ohms (600 kilo-ohm). The MS-FEC2621-0 equipment controller operates at 24 volts and a frequency of 50/60 hertz. The maximum power consumption for this field equipment controller is 20VA (volt-amp). The flash memory stores 1 megabyte of memory, but the random-access memory (RAM) for the MS-FEC2621-0 equipment controller is only 512 kilobytes (KB). The BACnet system is used for communication, and both the FC and the SA bus can be used in this system. The MS-FEC2621-0 controller is a multipurpose and adaptable solution for controlling various building field devices and equipment. It gives the intelligence and connectivity required for managing and integrating various systems, such as HVAC, lighting, and access control. This device is simple to use and install.

Technical Specifications for MS-FEC2621-0

ManufacturerJohnson Controls
SeriesMetasys MS series
Product TypeField Equipment Controller (FEC)
Control Points17-point controller
Power24 VDC/AC power
User InterfaceIntegral LCD and push button
ConnectivityRS-485 BACnet; MS/TP Bus
User InputLCD and push button
Storage512 kilobytes (KB)
Power Consumption20 voltsamps
Flash Memory1 megabyte

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.