1-800-360-6802
[email protected]

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-800-360-6802

Mon-Fri 8AM-5PM EST

[email protected]

AS-UNT141-1

★ ★ ★ ★ ★ Rated 0/5 Based on ratings.

Rate your purchase of the AS-UNT141-1

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

New

$750

6 In Stock

✓  2 Year PDF Supply Warranty

*Need a Specific Revision?

Refurbished

$490

Save $260

1 In Stock

✓  2 Year PDF Supply Warranty

The AS-UNT141-1 unitary controller from Johnson Controls is a control solution that supports advanced control system technology. This controller is used in HVAC systems. The AS-UNT141-1 controller’s system power requirements include 24 Volts AC at 40 VA and 50/60 Hertz in a typical type of system. The processor for the AS-UNT141-1 unitary controller is a 80C652 type of processor. It can support a Zone Bus interface and an N2 interface. The memory capacity for this unitary controller includes 8K of EEPROM, 64K of ROM, and 32K of RAM. The AS-UNT141-1 unitary controller has dimensions of 6.5 x 6.4 x 2.2 inches without an enclosure. Its rated shipping weight is 1.4 pounds. The AS-UNT141-1 unitary controller has 2 analog outputs and 6 binary outputs. Its analog outputs operate at 0 to 10V DC and 10 mA. The AS-UNT141-1 unitary controller supports a fixed screw terminal block for its I/O terminations. It includes a 6-pin phone jack. The AS-UNT141-1 unitary controller digitally controls a variety of devices in an HVAC system. These devices can include unit ventilators, heat pumps, fan coils, air-handling units, and other terminals or units that operate in a single room or zone. When the AS-UNT141-1 unitary controller is used with a Metasys network, it can support several basic I/O point-monitoring applications. This controller can operate as a standalone controller in a small system. The AS-UNT141-1 unitary controller uses an N2 bus to communicate with other devices in the system. It can be used in rooftop and fan coil applications.

Technical Specifications for AS-UNT141-1

TypeUnitary controller
SeriesMetasys
Voltage24 Volts AC
Input frequency50/60 Hertz
Power consumption40 VA
Binary output24 Volts AC while operating at 0.5 Amps or 0.8 Amps
Weight1.4 pounds (0.64 kilograms)
Operating temperature0 to 52 degrees Celsius
Analog outputs2
Binary outputs6
I/O terminationsFixed screw terminal block
StandardsFCC Part 15, Subpart B, Class A, IEEE 472, IEEE 587 Category A, UL 916, UL 864
Dimensions (H x W x D), without enclosure165 x 163 x 56 millimeters (6.5 x 6.4 x 2.2 inches)
Dimensions (H x W x D), with the AS-ENC100-0 enclosure173 x 185 x 119 millimeters (6.8 x 7.3 x 4.7 inches)

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.