1-800-360-6802
[email protected]

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-800-360-6802

Mon-Fri 8AM-5PM EST

[email protected]

IC200MDL730-PDF

SKU 2173106  UPC 09283204017210

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.

Product Description


Manufactured by GE Automation and Controls, the IC200MDL730 is a VersaMax series discrete output module. This device provides a single group of eight output points, which can be positive logic or sourcing types. The output points on this module are responsible for switching loads to the power supply’s positive side, thereby providing electrical current to all loads.

 

In addition to the standard backplane power supply, this module will require an external direct current power source to enable output load switching. The backplane power source must be stable for a minimum of one second before this device can accept field power. If field power is applied before the backplane is stable, a false output point fault is likely to occur. The external power source is required to supply a sufficient amount of field power to this product in the event that a short circuit is detected. For further external power supply requirements, see the product documentation.

 

The IC200MDL730 provides fault detection diagnostics and can determine if an overload or short circuit has occurred. Each output point on this module has the following protection mechanisms: Electronic Short Circuit Protection (ESCP) and overcurrent protection; however, channel to channel isolation is not supported.

 

Each output point is capable of handling up to 2 amperes of current when operating at 30 volts direct current, and the entire module is capable of driving a maximum of 8 amperes. The amount of current consumed from the 5-volt backplane is 50 milliamps. The output voltage for this module is anywhere from 17.5 to 30 volts of direct current. The nominal output voltage is 24 volts of direct current, and a maximum output voltage drop of 0.5 volts is acceptable.

Output 24VDC POS LOGIC 2.0 amp per point(1 group o 8) with ESCP 8 points IC200M IC200MD IC200MDL
ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

Common related search terms: Datasheet, Emerson, Manual, PDF, PLC, Price, Repair, Specification, User-Manual, Wiring, 

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.