1-800-360-6802
[email protected]

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-800-360-6802

Mon-Fri 8AM-5PM EST

[email protected]

STXDNS532

★ ★ ★ ★ ★ Rated 4.7/5 Based on 13 ratings.

Rate your purchase of the STXDNS532
GE Intelligent Platforms / GE Fanuc - RSTi PacSystem - STXDNS532

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

Other Available Revisions for the STXDNS532 STXDNS532ASTXDNS532BSTXDNS532CSTXDNS532DSTXDNS532ESTXDNS532FSTXDNS532GSTXDNS532HSTXDNS532ISTXDNS532JSTXDNS532KSTXDNS532LSTXDNS532MSTXDNS532NSTXDNS532OSTXDNS532PSTXDNS532QSTXDNS532RSTXDNS532SSTXDNS532TSTXDNS532USTXDNS532VSTXDNS532WSTXDNS532XSTXDNS532YSTXDNS532Z

Common misspellings:
  • STXDNS532

RSTi DeviceNet with 16 24VDC source (Negative Logic) input and 16 24VDC sink output built-in, expandable to 10 additional modules.

Technical Information

The STXDNS532 interface module is a DeviceNet network interface module manufactured by GE Fanuc. It is a negative logic module with 24 Volts DC input and output voltage. It has 16 input points and 16 output points. This communication module has built-in I/O and it supports expansion with up to 10 modules. This RSTi module is used in modern industries for automating application processes. It is notable for its reduced installation cost and it has a compact size. The STXDNS532 interface module is easy to install and it can be easily replaced. The front section of the network module has a color-coded module identification strip on the top. A removable terminal block is present in the front section that can be installed and replaced easily. The DeviceNet module accepts a spring clamp wire connection by using 14 AWG wire.  

 

The GE Fanuc STXDNS532 interface module runs with a voltage rating of 24 Volts DC with a field supply current of 10 Amps. The DeviceNet protocol is an industrial communication protocol that is made to communicate with different devices in the same network. It is mounted on the left side of the I/O rack. The module is certified with different industrial and environmental standards. The STXDNS532 interface module needs a clean environment with no EMC noise and corrosive gases in order to operate properly The ambient operating temperature should be set between -20 and 50 degrees Celsius with 5 to 90% ambient relative humidity without condensation. It comes with a variable baud rate that can be auto-negotiated as needed. The STXDNS532 interface module uses a dedicated DeviceNet cable with a 5 pin connector on the connector end. The cable length depends on the baud rate and it can range between 100 and 500 meters.

ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.