1-800-360-6802
[email protected]

GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

1-800-360-6802

Mon-Fri 8AM-5PM EST

[email protected]

IC660BBS101CA

★★★★★Rated 4.4/5 Based on 10 ratings.

Rate your purchase of the IC660BBS101

SKU 2175035  UPC 0216395329057

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.

The "CA" Revision is for the PDF Supply Conformal Coating Service. PDF Supply warranty will apply. A $150 service charge will be added at checkout.

IC660BBS103 replaces IC660BBS101

The IC660BBS101 is an isolated Genius I/O block by GE Fanuc with a power rating of 115 VAC or 125 VDC and an output current of 2 Amps with a frequency of between 47-63 Hz. The block weighs 4 lbs. with a block to block isolation of 1500 Volts. The block is fully compatible with handheld monitor IC660HHM501 and any GE Fanuc bus controller (PCIM or QBIM). Blocks numbered IC660CBS100, 1C660BBS100, and IC660BS101 are backward compatible with previous versions of this Genius I/O block.

The IC660BBS101 block comes with an array of LEDs, each circuit having its own LED. Should the circuit be configured as an input, the corresponding LED will indicate threshold voltage. However, if the circuit is configured to act as an output, the LED will indicate that the circuit is in a state commanded by the CPU. I/O block modules can be configured or set to act as input only, output only, or a combination of the two. The default setting is input only. If configured or set as input only, then all circuits should be set to either regular or tristate inputs. If configured or set as output only, all block circuits should be output only.

The isolated I/O blocks have the capacity to perform diagnostic checks such as over-temperature, absence of a load, sudden shutdown of the I/O block, failed switch, and power overload.  During field wiring, each terminal block can accommodate one AWG #12 or two AWG #14 wires. The minimum recommended wire size AWG #22. Spade or ring terminals of up to 0.27 inches in width can be accommodated by the terminal block. The user can connect a maximum of five power sources to the terminal assembly. 

CA - Conformal Coated IC660BBS101CA
ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

Common related search terms: Configuration, Datasheet, Emerson, Manual, PDF, PLC, Price, Repair, Specification, Troubleshoot, User-Manual, Wiring, 

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.