GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

Mon-Fri 8AM-5PM EST

IC630MDL356

Rated 4.6/5 Based on 12 ratings.

Rate your purchase of the IC630MDL356
IC630MDL356 In Stock! 24Vdc Sink Output Module, D Connector, w/LED IC630M IC630MD IC630MDL PDFsupply

SKU 2172240  UPC 0617426226435

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

New Surplus

$260

4 In Stock

✓  3 Year PDF Supply Warranty

*What is New Surplus?

Ships .

Surplus New

$195

Save $65

2 In Stock

✓  3 Year PDF Supply Warranty

*What is Surplus New?

Ships .

Reman

$129

Save $131

9 In Stock

✓  2 Year PDF Supply Warranty

*What is Remanufactured?

Ships .

24Vdc Sink Output Module, D Connector, w/LED MDL356 Series 3 IC630MDL3 IC630MDL35

Technical Information

The GE Fanuc IC630MDL356 output module is a 24 Volts DC sink output module which comes with a “D” connector. This module is also part of the Series Three line of modules made by GE Fanuc. The GE Fanuc IC630MDL356 output module comes with 2 channels, with either voltage outputs or current loop outputs. Users can configure each channel individually for a voltage range or current range depending on the requirements of the user’s application. All of the module configurations are done via a software program. However, the users must select the current input mode for a jumper. The system can be configured by using a Logicmaster Series 90-30 programming software configurator function, or the Series 90-30 hand-held programmer.

 

The users can configure each output channel on the IC630MDL356 output module to operate in the ramp mode by using ladder logic. The ramp output comprises the steps taken by the module in every millisecond to arrive at the final value. Additionally, the users can set high and low alarm limits on every channel, and an open-wire fault can be reported to the CPU for both output channels. The users should never insert or remove the GE Fanuc IC630MDL356 output module when the power is still connected. This can cause serious damages to the baseplate or module and even lead to serious injuries to the person handling the module. Moreover, this can make the PLC stop or break down. Additionally, voltage spikes from the user devices can be found on the screw terminals of the module, even when the users have turned off the power. Therefore, the users must always exercise caution when handling the GE Fanuc IC630MDL356 module or the wires connected to the module.

ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.