GE / IP FANUC Series 90/30 In Stock

World's Largest Warehouse

of GE 90-30, Genius, and RX7i

Mon-Fri 8AM-5PM EST

IC655PWR501

Rated 4.4/5 Based on 14 ratings.

Rate your purchase of the IC655PWR501
IC655PWR501 In Stock! GE Power Supply, 12 Amp, 115/230Vac IC655P IC655PW IC655PWR PDFsupply also rep

SKU 2175340  UPC 0644592923233

All product names, trademarks, brands and logos used on this site are the property of their respective owners. PDF Supply is not an authorized distributor, reseller or representative of the products featured on this website. The depiction, description or sale of products featuring these names, trademarks, brands and logos is for identification purposes only and is not intended to in indicate any affiliation with or authorization by any rights holder.

PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.

New Surplus

$513

41 In Stock

✓  3 Year PDF Supply Warranty

*What is New Surplus?

Ships .

Reman

$371

Save $142

9 In Stock

✓  2 Year PDF Supply Warranty

*What is Remanufactured?

Ships .

GE Power Supply, 12 Amp, 115/230Vac PWR501 Series Five Power IC655PWR5 IC655PWR50

Technical Information

The IC655PWR501 Power Supply Module is manufactured by GE Fanuc for the GE Series Five PLCs. It supplies the required operating voltage and current to the base units of the PLC. The IC655PWR501 Power Supply Module can be installed in the leftmost slot on the base unit. The input voltage rating of the device is 115/230 Volts AC and the current rating is 12 Amps. The input voltage is selected by configuring the jumper which can be found on the terminal block on the front of the power supply module. The terminal block of the module is located at the lower right of the power supply module. The terminal block can also be used for making field wiring connections and it comes with a snap-on plastic terminal cover for the safety of the users.              

 

The IC655PWR501 Power Supply Module provides 5 Volts DC of regulated voltage to the backplane of the base unit for supplying power to the modules which are installed in the base units. The IC655PWR501 Power Supply Module has an indicator LED which is known as the “PWR” LED to indicate the status of the power supply which is located at the top right corner of the module. The terminal block with 8 terminals can be used for RUN relay connections, power source connections, power source selections, and ground connections. The first 2 terminals that have the RUN label on them are connected internally to normally-open contacts that close when the CPU is switched to the RUN mode. The third and fourth terminals have internal connections to the signal ground and chassis ground, respectively. The next 2 terminals are used to connect the power source and the last 2 terminals are used for power source selection.      

ST. LOUIS, Feb. 1, 2019 – Emerson today announced it has completed the purchase of Intelligent Platforms from General Electric.

PDF Supply sells used surplus products. PDF Supply is not an authorized distributor, affiliate, or representative for the brands we carry. Products sold by PDF Supply come with PDF Supply’s 1-year, 2-year, or 3-year warranty and do not come with the original manufacturer’s warranty. Designated trademarks, brand names and brands appearing herein are the property of their respective owners. This website is not sanctioned or approved by any manufacturer or tradename listed.

Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.