GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1747-AIC
1747-AIC
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1747-AIC 1747-AIC//A1747-AIC//B
Common misspellings:
- l747-AIC
- 17A7-AIC
- 1747-A1C
- 1747-AlC
- 1747AIC
Technical Specifications for 1747-AIC
| Manufacturer | Allen-Bradley / Rockwell Automation |
|---|---|
| Series | SLC 500 |
| Part Number | 1747-AIC |
| Product Type | Isolated link coupler |
| Compatibility | SLC 500 controllers and peripheral devices |
| External Power Supply | 24 Volts DC (Class 2) |
| Minimum Power Draw | 2 Watts |
| Maximum Power Draw | 2 Watts |
| Power Draw | 1500 Volts DC |
| DH-485 Cable | Belden #9842 |
About 1747-AIC
The Allen-Bradley 1747-AIC device is an isolated link coupler for the SLC 500 controllers which is used to connect devices from the SLC 500 family to the DH-485 network. The coupler comes with a 6-position RTB (removable terminal block) for DH-485 cable connection. A 12-inch cable supplied with the 1747-AIC coupler (catalog number 1747-C11) is used to provide a network connection for the SLC 500 controller. A 6-foot cable with the catalog number 1747-C10 is required to provide network connections for peripheral devices such as hand-held terminals, data table access modules, and personal interface converters. Up to 1500 Volts DC isolation is provided by the coupler between the cables and connected drives to protect the connected controllers and peripheral devices. The 1747-AIC coupler also provides connectivity for peripheral devices for distances of up to 4000 feet.The Allen-Bradley 1747-AIC coupler is powered by the controller when it is connected to the controller. If the link coupler is not connected to the controller, then an external Class 2-rated 24 Volts DC power supply is required. The chassis ground terminal on the link coupler must be grounded before it is put into operation. Both the minimum and maximum power draw of the 1747-AIC coupler is 2 Watts. The cable recommended for the DH-485 network connections is Belden #9842 cable. This is a jacketed cable which is shielded and contains 2 twisted wire pairs and a drain wire. One pair of wires is used to provide a balanced line signal. The other wire pair is used as a common reference. The shield on the cable reduces the effect of external noise.
