GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1746-P6
1746-P6
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1746-P6 1746-P6//A
Common misspellings:
- l746-P6
- 17A6-P6
- 1746P6
The 1746-P6 is a power supply module from Allen-Bradley and it forms part of the SLC 500 series. It has a line voltage rating of 30-60V DC, and it has a 5A and a 0.96A current capacity at 5V DC and 24V DC, respectively, a 0.2A current capacity (user) at 24V DC, and a maximum inrush current of 20A. The 1746-P6 module does not have jumpers. The user output voltage ranges from 18-30V DC. The 1746-P6 uses a maximum of 2 #14 AWG wires per terminal. The terminal screws on the module should not exceed 1Nm torque when tightening. To supply power to the 24V DC sensors and loads, use the PWR OUT +24V DC plus the PWR OUT COM terminals. The module provides 200mA non fused isolation at 24V DC.
The 1746-P6 requires a line power of 100VA, and a terminal and backplane isolation of 1800V AC RMS for 1 sec. At full load, the 1746-P6 has a CPU hold-up of 5ms and 1500ms at no load. The 24V DC user power can power the AIC+. When using the 1746-P6, a hard-wired connection is required to supply power to the link coupler.
The 1746-P6 has an operating temperature rating of 0-60 degrees Celsius, and a storage temperature of -40-85 degrees Celsius. The 1746-P6 has certifications for Class 1, Division 2 hazardous locations, and UL, CE, and c-UL approval. The module is supposed to be used in environments that have a relative humidity of 5-95% without condensation. The module is 5.5” by 3.6” by 5.7” in dimensions and should be mounted on the 1746 chassis.
