GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1746-P3
1746-P3
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1746-P3 1746-P3//A
Common misspellings:
- l746-P3
- 17A6-P3
- 1746P3
The Allen-Bradley 1746-P3 is a power supply that dissipates 24V DC. It accommodates a voltage range (input) of between 19.2V and 28.8 V AC. The 1746-P3 has a current capacity of 3.6 amperes at 5V DC and 0.87 amperes at 24V DC. The power supply has a maximum inrush current of 20 amperes, and a minimum operating temperature rating of 0 degrees Celsius and a maximum one of 60 degrees Celsius. The 1746-P3 power supply must be operated in environments that have a relative humidity of 5-95% without condensation.
When wiring the 1746-P3 power supply, use two 14AWG wires per terminal. The 1746-P3 measures 5.5 x 2.9 x 5.7 inches and it weighs 2.5lb. The 1746-P3 power supply module has a 5% current capacity deration when operated at temperatures above 55 degrees Celsius. The output loading of the 1746-P3 changes when the power dissipation changes. The power supply is fused to protect against hazards that may occur due to short circuits. Transient faults are not accommodated by the fuse on the 1746-P3 power supply. The 1746-P3 is recommended to be used in industrial environments with a level two pollution rating.
When handling the 1746-P3, be extra careful not to cause an electric arc. The arc results when you operate loads (discharge, insert, connect or disconnect the power supply) without first switching off the 1746-P3 power supply. An electric arc is likely to cause detrimental conditions like explosions, which can injure personnel and damage other devices and modules. The 1746-P3 is used together with a replaceable terminal block which makes replacing loads or the 1746-P3 power supply easier.
