GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1746-IO12DC
1746-IO12DC
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1746-IO12DC 1746-IO12DC//A
Common misspellings:
- l746-IO12DC
- 17A6-IO12DC
- 1746-1O12DC
- 1746-lO12DC
- 1746-I012DC
- 1746-IOl2DC
- 1746IO12DC
The Allen Bradley 1746-IO12DC is an SLC 500 Digital Input/Output Combination Module. It has six points for each common; six 24 Volt DC input points and six 100 to 120 AC relay contact output points. The voltage range at which its input points operate is around 10 to 30 Volts, while its output points operate at 5 to 265 Volts AC between 47 to 63 Hertz, or 5 to 125 Volts DC between 47 to 53 Hertz. The backplane current load is 80 mA at 5 Volts DC or 60 mA at 24 Volts DC. The maximum current output of the 1746-IO12DC module is 2 A with a power output of 28 VA maximum. There is a signal delay in its “OFF” state of 45 milliseconds; this signal delay is only 35 milliseconds in the module’s “ON” state. There are .20 Watts for each input point and .133 Watts for each output point, while 3.90 Watts is the maximum thermal dissipation, and 1.84 Watts is the minimum.
The 1746-IO12DC is configured by using removable terminal blocks. It has several LED indicators, one for each input point, to simplifying troubleshooting procedures. This combination module is open-type equipment and should be mounted in a suitably designed enclosure that meets the operating requirements. The environment should typically be between -4 and 85 degrees Celsius with a 5 to 95% non-condensing humidity. The combination module is designed to fit any slot, except the 0 slot, which is reserved for the processor.
The entire 1746-IO12DC module provides 8 Amperes of continuous current. It has K1 to K6 relays and is CSA and C-UL certified in addition to offering NEMA standard ICS 2-230 noise immunity.
