GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1746-BAS
1746-BAS
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1746-BAS 1746-BAS//A1746-BAS//B1746-BAS//C
Common misspellings:
- l746-BAS
- 17A6-BAS
- 1746-8AS
- 1746BAS
The Allen-Bradley 1746-BAS is a single-slot module under the SLC 500 series. The 1746-BAS is compatible with the fixed or modular controller chassis of the SLC 500 series. The 1746-BAS has 2 configurable serial ports used for RS-232, RS-485 and RS-422 communication with I/O devices. The 1746 I/O backplane or the DH-485 channel can be used for communication with a SLC 500 via the module’s DH-485 port.
The 1746-BAS has 24K bytes battery-supported RAM with a voluntary 8K or 32K byte EEPROM memory modules that are nonvolatile. It also features LED indicators to enhance operation monitoring. The 1747-M1, 1747-M2, 1747-M3 and the 1747-M4 memory modules are compatible with the 1746-BAS.
The PRT1 communication port on the 1746-BAS is a serial port. It is used to interface the module with external devices. This port has the RS-232/RS-423, RS-422 and RS-485 communication ports. The PRT1 port has full duplex capabilities and can operate at 300, 600, 1200, 2400, 4800, 9600 and 19200 bps. The 1746-BAS has two extra ports: the PRT2 and DH-485 port. The PRT2 port is used to interface the module with external devices using the DFI protocol. This port has full duplex capabilities. The DH-485 port is used to connect the module to a DH-485 network. To use the DH-485 port the 1747-AIC link coupler must be used to connect the port with the DH-485 network. Note that when the DFI protocol is enabled on PRT2 the DH-485 communication is inactive.
