GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » SLC-500 » You are here: 1746-A7
1746-A7
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1746-A7 1746-A7//A1746-A7//B
Common misspellings:
- l746-A7
- 17A6-A7
- 1746A7
The Allen-Bradley 1746-A7 is a mounting rack with 7 slots that is part of the SLC 500 family of products. The 1746-A7 mounting rack is used to hold processors and modules from the SLC 500 family. For expansion, three extra racks can be connected to the 1746-A7 by interconnecting cables. The cables that can be used with the 1746-A7 are the 1746-C7, 1746-C9, and 1746-C16. There are no replacements for these cables. The 1746-A7 requires individual power supply mounted on the far left of the chassis. The 1746-A7 modular chassis accommodates the processor, adapter module, and the I/O modules all in one place.
While mounting the 1746-A7, allow for sufficient mounting space. Leave a space of 6 inches between the modules/controllers and the 1746-A7 rack on both the top and bottom. Leave 4 inches on both the right and left side of the rack. When installing the 1746-A7 chassis, make holes in the enclosure's back panel to introduce chassis mounting. Install the hardware for the top mounting tabs. Slide the chassis over the installed hardware and tighten the screws. Install the remaining tab hardware leaving the far right and left tabs open to cater for grounding.
Without modules in the rack, the 1746-A7 weighs 2.4 lbs. The dimensions of the 1746-A7 are 11.3 x 6.8 x 5.8 inches. The operating temperature for the rack ranges between 0-60 degrees Celsius (32-140 degrees Fahrenheit) and it has a storage temperature between -40-85 degrees Celsius (-40-185 degrees Fahrenheit). In addition, it has a relative humidity rating of 5-95% in a non-condensing environment. The 1746-A7 is manufactured for use in Class I, Division 2, Groups A, B, C, and D in a non-hazardous setting.
