GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-P10
1771-P10
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-P10 1771-P10//A
Common misspellings:
- l771-P10
- 177l-P10
- 1771-Pl0
- 1771-P1o
- 1771P10
The Allen-Bradley 1771-P10 is a Power Supply Module. It outputs 8 Amps of current to the I/O chassis at 5 Volts DC. This module can power up both series A and B of 1771 series I/O chassis. The input terminals of this unit must be connected to 97 to 145 Volts DC voltage for proper module operation. This module can be used with processors, without requiring an integral power supply. It cannot, however, be used with 1772-LSP, 1772-LWP, or 1772-LXP processors. The list of processors that this power supply module applies to includes 1772-LS, 1772-LW, 1772-LX, 1771AL, 1771AR2, 1771ASB, and 1771-AS. The 1771-P10 power supply should not be connected in parallel to any other power supply unit except another 1771-P10 power supply. There is a parallel connector on the front of the device that can be used for connecting 2 of these power supplies. The interface of the 1771-P10 consists of LED status indicators that show module status, 1.5 Amps 250 Volts slow blow fuse, power switch, and connecting terminals.
Be sure to turn the power switch to off position and to turn off I/O chassis power when installing this device into desired I/O chassis slot. Put keying bands between pins 12 and 14 and between 20 and 22 for proper module configuration. The 1771-P10 module monitors itself for overvoltage, undervoltage, and overcurrent conditions. If there is an alarm, the user will be notified of it over the LED status indicator. The 1771-P10 Power Supply Module can operate at 0 to 60 degrees Celsius (32 to 140 degrees Fahrenheit) temperatures and you can store it at-40 to 85 degrees Celsius (-40 to 185 degrees Fahrenheit) temperatures.
