GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-OG
1771-OG
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-OG 1771-OG//A
Common misspellings:
- l771-OG
- 177l-OG
- 1771-0G
- 1771OG
The 1771-OG is a TTL output module to be used with the 1771 systems from Allen Bradley. Any TTL device that meets the criteria of the logic level specification can be used. The logic level specification for a signal to be low is -0.2 to 0.8 Volts DC and for a signal to be considered as high the voltage should be 2.0 to 5.25 Volts DC. The 1771-OG requires around 5 Volts DC. The module can be powered from the backplane of the I/O chassis and it draws a current of 168 milli-Amp. You can also connect an external power supply which provides 5 Volts DC and having a minimum current capacity of 250 milliAmps.
When installing the module, it is necessary to wear wrist strap grounding device to discharge any static charge to prevent damage due to electrostatic discharge. The user should not touch any connectors or pins without discharging the static charge as the device is sensitive to electrostatic discharge. The 1771-OG has 8 outputs and the maximum output source current is 1 milliAmps and the sink current is 20 milliAmps. The maximum power dissipation of the device is 2.2 Watts. The operating temperature of the module should be 0 to 60 degrees Celsius and the storage temperature should be -40 to 85 degrees Celsius in a non-condensing humid environment having humidity of 5 to 95%. The power to the I/O chassis should be turned OFF when replacing the 1771-OG.
