GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-IGD
1771-IGD
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-IGD 1771-IGD//A
Common misspellings:
- l771-IGD
- 177l-IGD
- 1771-1GD
- 1771-lGD
- 1771IGD
The 1771-IGD from Allen Bradley is a 16 Input/Output digital module used to interface BCD interface encoders in an A-B bulletin 854C. The 1771-IGD operates at a voltage of 5 Volts and within a voltage category of between 5.0 and 5.3 Volts that is Transistor Transistor Logic (TTL) compatible. The 1771-IGD has a peak to peak maximum ripple of 50 mV. The module has an input signal delay of less than 1 millisecond. The 1771-IGD has a maximum power dissipation of 2.7 Watts and a minimum of 0.4 Watts. The minimum and maximum thermal dissipation for the 1771-IGD is between 1.4 and 9.2 BTU per hour. To protect against power surges, the digital Input/Output module has a blow fuse normal that is rated ½ Amperes at 250 Volts.
The 1771-IGD should be operated at temperatures ranging between 0 and 60 degrees Celsius, a storage temperature that does not exceed 85-degree Celsius cannot drop lower than -40 degrees Celsius. Additionally, the module should be operated within a relative humidity of between 5 & 95% without condensation. For one second, the 1771-IGD module has an isolation voltage of 1500 AC RMS. The 1771-IGD exerts a load of 130 mA on the backplane. The 1771-WH wiring arm is used when wiring the module to reduce the need the rewire the system in case the 1771-IGD needs to be replaced. The 1771-IGD module has logic status switches’ which uses voltage difference to indicate ON and OFF. Voltages between -0.2 to +0.8 and 2 to 5.3 are used to indicate ON and OFF in any order depending on the logical switch setting.
