GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-DL
1771-DL
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-DL 1771-DL//A
Common misspellings:
- l771-DL
- 177l-DL
- 1771-D1
- 1771DL
The 1771-DL is a Gray Code Converter from Allen Bradley. The 1771-DL has 15 mA per bit at 27 DC and a 6 mA per bit at 10 Volts DC on an input sourcing current. This module is powered by a 12 or 24 Volt DC power source, which is attached between the absolute encoder and the 1771-WB wiring arm. The zero speed triac switch is turned on when the encoder is moving, and will turn off when the 1771-DL gray code converter module has sensed the motion and has stopped and on a selectable time. The 845A-SJZ3DN6DW, which is an 8-bit gray encoder bulletin, is compatible with the 1771-DL module. The PLC controller uses an 8 bit input, which is sourced from the 8-bit grey code and converted to an 8-bit binary number. The time delay of the 1771-DL can be set to between 6 and 0.3 seconds using the trim lock (knob) on the face of the module. This is done by turning the counter knob either clockwise or counterclockwise to increase and decrease the delay respectively. This knob also acts as a safety-interlock, which can be used to open the drive circuit when an encoder failure occurs. The 1771-DL module is rated for operation at temperatures not exceeding 60 degrees Celsius and not below 0 degrees Celsius. This module should be stored within temperatures that ranging from -40 to +85 degrees Celsius and has an off-state maximum current leakage of 5mA, along with an on-state voltage drop of 2 Volts and a load current of 100mA. The 1771-DL communicates with a processor through the backplane, where it provides 8-bit 0-255 binary of output data to the processor.
