GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-DBMEM1
1771-DBMEM1
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-DBMEM1 1771-DBMEM1//A
Common misspellings:
- l771-DBMEM1
- 177l-DBMEM1
- 1771-D8MEM1
- 1771-DBMEMl
- 1771DBMEM1
The 1771-DBMEM1 is a memory module from Allen Bradley that is used with a 1771-DB BASIC module. The 1771-DBMEM1 is an EEPROM memory module with 8 Kb. To increase the user memory on a 1746-BAS-T module, the JW3 is used to configure the memory modules to accept the 1771-DBMEM1. Before installing the 1771-DBMEM1 into the 1771-DB BASIC module, disassemble the module after removing it from the Input Output chassis. Memory modules are very sensitive to electrostatic charges; before attending to the 1771-DBMEM1 module, wear a wrist-strap grounding material/device to discharge yourself. Alternatively, touching a grounded object will give the same effect. Electrostatic charges can damage the semiconductors and integrated circuits in the module. Do not touch the backplane connector pins when uninstalling the 1771-DB BASIC module. When inside the 1771-DB module, insert the 1771-DBMEM1 memory module in the SKT1 slot, and reassemble the 1771-DB BASIC module.
Use the JW2 jumper to select the PROM circuitry, and use the JW3 jumper to set the CPU speed. Carefully fix the 1771-DB module back to the Input Output chassis. The 1771-DBMEM1 can be programmed using the personal computer with a 1746-PBASE BASIC development program, or an ASCII terminal. The 1771-DBMEM1 operates optimally at temperatures of between 0 and 60 degrees Celsius and should be stored at temperatures of between -40 and 85 degrees Celsius. The 1771-DBMEM1 also operates best at a humidity of between 5 and 95% without condensation. When not in use, store the 1771-DBMEM1 memory module in a static-shielded bag.
