GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-CP3
1771-CP3
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-CP3 1771-CP3//A
Common misspellings:
- l771-CP3
- 177l-CP3
- 1771CP3
The 1771-CP3 cable from Allen Bradley is used to interface the 1771-P7 power supply with the 1771 Input-Output rack. When purchasing the 1771-CP3, it comes with 2 screws and 2 cable ties. One screw and one cable tie is used to hold the 1771-CP3 cable on the 1771-P7 power supply, while the remaining screw and cable tie is used to hold the 1771-CP3 cable on the 1771 Input-Output rack. When connecting the 1771-CP3, make sure to connect the right-angled side of the cable to the rack. Use one screw to tighten it into place, and use the cable tie to hold it against the rack backplane connector. The other end of the cable goes to the bottom side of the 1771-P7 power supply, where it is connected to a D-shell connector. Carefully insert the cable into the slot, being careful not to force it. Use the remaining screw and cable tie to screw it tight and hold it in place, using the cable tie. Do not apply the connections when the power supply is turned on. When removing the 1771-CP3, turn off the 1771-P7 power supply first.
Disconnecting and connecting the power supply while the power is turned on can cause an electrical arc, which may lead to an explosion when in a hazardous environment. The 1771-CP3 cable measures 5.5 feet, or approximately 1.7 meters. The cable can provide connection to the 1771-A1, 1771-A2B, 1771-A3B1, and the 1771-A4B Input-Output racks. When the power supply is installed outside the I/O chassis, it should be placed above the chassis to allow for proper air circulation in the Input-Output chassis.
