GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-CP2
1771-CP2
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-CP2 1771-CP2//A
Common misspellings:
- l771-CP2
- 177l-CP2
- 1771CP2
The Allen Bradley 1771-CP2 cable connects the remote 1771-P7 power supply module to a rack-mounted 1771 Input-Output chassis. The 1771-CP2 is 5 feet (1.5a2 meters) long. When connecting the cable to the 1771-P7 power supply and the Input-Output chassis, ensure that the power supply is not turned on. When fixing the power cable, it should be given sufficient allowance to bend; this allowance will prevent excessive stress from being applied to the connectors that hold the cable in its place on the power supply and the Input-Output chassis. A space of 6 inches should be left between the I/O chassis and the power supply during the mounting process. To install the 1771-CP2 cable, one end should be connected to the D-shell connector situated at the power supply’s bottom; the cable is then tightened with the small screws found on its either side. The other end of the cable should be connected to the D-shell connector on the Input-Output chassis. Tightening the small screws on the 1771-CP2 cable will hold it in place.
The small screws on the 1771-CP2 should be tightened with care, in order to prevent damaging the D-shell connector. The 1771-CP2 does not provide grounding; therefore, use the 14 AWG type wire to interface the ground (GND) terminal and the ground bus when grounding the cable. To ensure maximum performance of the 1771-CP2 and other Input-Output modules, the Input-Output chassis should compensate for an enhanced ventilation. This can be achieved by following the standard spacing procedures when mounting the modules and the 1771-CP2 cable.
