GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-A2B
1771-A2B
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-A2B 1771-A2B//A1771-A2B//B
Common misspellings:
- l771-A2B
- 177l-A2B
- 1771-A28
- 1771A2B
The Allen-Bradley 1771-A2B is an input and output back-panel-mounted chassis that houses Allen-Bradley 1771 input/output modules. It has 8 slots. The 1771-A2B comes in an open enclosure weighing approximately 10.3 pounds and spanning 12.4 x 9 x 14 inches. The backplane facilitates communication between the installed modules and processor.
The 1771-A2B chassis can receive its power from external power supplies, power supply modules, and from processors that have integrated power supplies. A load of 16 amps at 5V DC is the highest operating backplane current load that the 1771-A2B can handle. The chassis can be grounded by using the grounding studs which are connected to a central ground bus. It also functions optimally at temperature ranges of 0 to 60 degrees Celsius and in 5-95% relative non-condensing humidity.
The power supply for the 1771-A2B chassis is set using the configuration jumper. To configure the chassis to work with an external power supply it is set to the “N” position, and when it is receiving power from a power supply module or from a processor with an integrated power supply, it is set to the “Y” position. The 1771-A2B chassis can be powered by both of these sources, but only by one at a time.
The 1771-A2B is intended for use in an industrial environment with a Pollution Degree 2 pollution rating. Ensure that the spacing inside of the enclosure is adequate for the components (chassis) to be installed. There should be at least 4 inches between the side of the enclosure and a major component (chassis). Likewise, there should be 4 inches horizontal distance and 6 inches vertical between the major components.
