GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » PLC-5 » You are here: 1771-A1B
1771-A1B
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1771-A1B 1771-A1B//A1771-A1B//B
Common misspellings:
- l771-A1B
- 177l-A1B
- 1771-AlB
- 1771-A18
- 1771A1B
The 1771-A1B by Allen Bradley is an input/output chassis that serves as housing for 1771 input/output modules. It is a back-panel mounting type chassis with 4 slots and it is protected by an open enclosure that weighs approximately 8 pounds and measures 12.4 x 9 x 7.6 inches. This chassis provides a path of communication between either the input/output adapter module or the controller and the various input or output modules that are installed. The 1771-A1B can house power-supply modules, a processor, input/output modules, and remote and extended local input/output adapter modules. The slot to the far left is reserved for the installation of the adapter module or the processor. The remaining slots can be used for installing the power supply, communication modules, and the input/output modules.
The 1771-A1B chassis can receive power from external power supplies that yield 6.5 to 16 amps, from power supplies which yield 3 to 8 amps, and from processors with integrated power supplies yielding 2 to 4 amps. The highest operating backplane current load that it can handle is 16 amps at 5V DC. Make sure that the chassis is grounded by connecting the 1771-A1B to a central ground bus with the grounding studs. The configuration jumper is used in setting up the power supply for the chassis. When it is in the “N” position, it is working with an external power supply and the “Y” position is used when it is being powered by a processor with an integrated power supply or a power supply module. The 1771-A1B chassis can receive power from either one of these power sources, but not simultaneously.
