GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » ControlLogix » You are here: Logix5563
Logix5563
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the Logix5563 Logix5563//A
Common misspellings:
- 1ogix5563
- L0gix5563
- Logix5563
The Logix5563 is a ControlLogix processor from Allen Bradley. The processor has a user memory of 8 megabytes and can handle 32 tasks with 100 programs per task. The Logix5563 is also referred to as the 1756-L63 controller. This processor communicates with other devices in a system using the single built-in RS-232 serial port. The processor can handle a maximum of 250 controller connections. The Logix5563 is part of the Logix5000 family of controllers. and accommodates either EtherNet/IP, ControlNet, DeviceNet, Data Highway Plus, Remote I/O, SynchLink, or third party process and device networks communication options.
The serial port available on the Logix5563 supports ASCII, DF1 half/ full duplex, DF1 radio modem, DH-485, and Modbus via logic communications. The processor is powered from the backplane where it draws a current of 1.2 Amperes at 5.1 Volts DC and 14 milliamperes at 24 Volts DC. The Logix5563 dissipates 3.5 Watts and has a heat dissipation rating of 11.0 BTU per hour. The Logix5563 has a basic insulation type which has been tested for 60 seconds at a voltage of 720 Volts AC to record a 30 volts continuous isolation voltage. The Logix5563 ControlLogix supports maximum analog and digital I/O connections of 4000 and 12800, respectively. For a backup memory, the Logix5563 supports the use of either the 1784-CF64 (64 megabytes) or the 1784-CF128 (128 megabytes) CompactFlash card. The Logix5563 also uses a battery to back up the volatile memory. Connections to the Logix5563 are made through a terminal block with slots available on the processor to key the terminal block. A locking tap is also available to anchor the terminal block on the Logix5563.
