GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » ControlLogix » You are here: 1756-TBSH
1756-TBSH
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1756-TBSH 1756-TBSH//A
Common misspellings:
- l756-TBSH
- 1756-T8SH
- 1756TBSH
The 1756-TBSH is a 20-pin spring clamp removable terminal block (RTB) with a standard housing. The RTB provides a link between the I/O module and the plant wiring. This module needs to be ordered separately from the module. When wiring the RTB with the module, make sure to start connecting the wires from the bottom and then move up. This makes it easier for connecting the wires along with increasing visibility. Operators can use cable ties to secure the wires in the strain relief areas on the RTB and they can also use the extended depth housing with a heavy gauge wire. The extended depth housing needs to be ordered separately. While connecting the 1756-TBSH RTB, make sure the power is turned off because if users connect the RTB to the module with the power on, it may cause electric arcs and this may cause explosions in hazardous locations. It may also damage the equipment and be dangerous for the person installing the system.
When the users first receive the 1756-TBSH module, they should make sure that the packaging is intact and that there is no damage to the module. If there is any, they should inform the supplier about the damage before proceeding with the installation. All the necessary installation instructions and the safety instructions stated by the manufacturer must be followed for the safety of the personnel. It is recommended that the installation of the module be done by a person who is familiar and trained with the system. Users can refer the manuals for the connection diagrams and detailed installation instructions for the 1756-TBSH. For further assistance with regards to the installation, users can contact the local distributor or the manufacturer.
