GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » CompactLogix » You are here: 1769-ECL
1769-ECL
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1769-ECL 1769-ECL//A
Common misspellings:
- l769-ECL
- 1769-EC1
- 1769ECL
Terminator Left End Cap
The 1769-ECL terminator is an end cap terminator that has been manufactured and distributed by Allen-Bradley/Rockwell Automation to be used with the Allen-Bradley 1769 Compact I/O controllers. The main function of this end cap terminator is to terminate the end of the communication bus, and this specific end cap is for the left side of the bus. This end cap terminator has a width of 87 millimeters, a depth of 15 millimeters, and a length of 118 millimeters. The Allen-Bradley/Rockwell Automation 1769-ECL end cap terminator has a current draw of 5 milliamps at a specific voltage of 5.1 Volts DC and it can operate at a maximum altitude of 2000 meters. The temperature of the room must meet the North American temperature code.
The Allen-Bradley/Rockwell Automation 1769-ECL end cap terminator has a shipping weight of 130 grams and it does not come with an enclosure, but with an open design. The operating temperature for this part needs to be higher than 0 degrees Celsius and lower than 60 degrees Celsius. It can also withstand vibrations of 5 G at 10 to 500 Hertz and operating shocks of at least 20 to 30 G. The Allen-Bradley/Rockwell Automation 1769-ECL end cap terminator can be mounted on a DIN rail or on a panel as long as these mounting bases are properly secured. This part must not be exposed to direct sunlight or any other source of radiation and it needs to be properly protected. The equipment must not be installed, connected, or disconnected while power is being applied to the circuit. It is also recommended that technicians perform static discharging techniques before attempting to install this part since electrostatic discharge might cause damages.
