GE / IP FANUC Series 90/30 In Stock
Home » Allen Bradley » 1788 linking devices » You are here: 1788-cn2dn
1788-cn2dn
Rockwell Disclaimer: The product is used surplus. PDF Supply is not an authorized surplus dealer or affiliate for the Manufacturer of this product. The product may have older date codes or be an older series than that available direct from the factory or authorized dealers. Because PDF Supply is not an authorized distributor of this product, the Original Manufacturer’s warranty does not apply. While many Allen-Bradley PLC products will have firmware already installed, PDF Supply makes no representation as to whether a PLC product will or will not have firmware and, if it does have firmware, whether the firmware is the revision level that you need for your application. PDF Supply also makes no representations as to your ability or right to download or otherwise obtain firmware for the product from Rockwell, its distributors, or any other source. PDF Supply also makes no representations as to your right to install any such firmware on the product. PDF Supply will not obtain or supply firmware on your behalf. It is your obligation to comply with the terms of any End-User License Agreement or similar document related to obtaining or installing firmware.
PDF Supply is NOT an authorized distributor for this manufacturer and therefore the manufacturer’s warranty does not apply. Product comes with PDF Supply's 1-year, 2-year, or 3-year warranty.
Other Available Revisions for the 1788-cn2dn 1788-cn2dn//A
Common misspellings:
- l788-cn2dn
- 17b8-cn2dn
- 178b-cn2dn
- 1788cn2dn
Technical Specifications for 1788-cn2dn
| Brand | Allen-Bradley / Rockwell Automation |
|---|---|
| Series | 1788 linking devices |
| Part Number | 1788-CN2DN |
| Product Type | Linking device |
| Controlnet Network | Supported |
| Devicenet Network | Supported |
| Voltage Type | DC |
| Voltage Range | 18 to 32 Volts DC |
| Mounting | DIN rail |
| Included connector | 10-pin linear connector |
About 1788-cn2dn
The 1788-CN2DN linking device from Allen-Bradley is an industrial Controlnet to Devicenet linking device in the 1788 linking device series. It can be installed with a 24 Volts DC rated power supply and a mounting base that is either a DIN rail made out of yellow-chrome steel with a zinc-plate coating or another mounting base with similar specifications. The cable that the 1788-CN2DN linking device uses to connect to the Devicenet network should not be connected to the device or disconnected from it while it is powered up because this can cause a dangerous electrical arc. The 1788-CN2DN linking device connects to the Devicenet network with either a 10-pin linear connector that is included with it or with another type of linear connector that is not included such as a 5-pin linear connector or linear to micro connector.
The Allen-Bradley 1788-CN2DN linking device cannot display its own status code, so the users must check its status codes on the display of the Devicenet scanner module that it is connected to. This scanner module can also be used to troubleshoot the 1788-CN2DN linking device if necessary. This linking device can be powered from multiple sources as long as the voltage that they provide does not exceed the specified isolation voltage rating of the linking device. The 1788-CN2DN linking device should also always be protected from ESD. This device uses DC power in the 18 to 30 Volts DC range, and this power must come from a power supply that is separate from the Devicenet network’s power supply. The complete setup with the 1788-CN2DN linking device includes the linking device, the Devicenet connector, the power connector, 121-Ohm resistors, and end anchors.
The Allen-Bradley 1788-CN2DN linking device is a 1788 linking device. It operates on DC power and it connects the Controlnet network to the Devicenet network.
F.A.Q for 1788-cn2dn
